Flat Ribbon Cables

Parallel-conductor flat cables engineered for high-density internal wiring and rapid mass IDC termination across fine-pitch, standard-pitch and halogen-free constructions.

Parallel-conductor geometry & mass IDC termination

Flat ribbon cables arrange parallel insulated conductors on a precise, repeatable centre-to-centre pitch — such as 0.635 mm, 1.27 mm (0.050 in) or 2.54 mm — enabling simultaneous mass termination to Insulation Displacement Connectors (IDCs) without individual wire stripping. Compared with bundled round wiring, a planar profile saves enclosure height, maintains uniform electrical spacing between adjacent channels and simplifies automated harness assembly.

Selecting a flat ribbon construction requires matching conductor gauge, stranding and pitch directly to the connector interface while checking finished overall width and thickness tolerances independently. Insulation systems span flame-retardant PVC for general electronics and halogen-free XLPE or TPE compounds for environmentally regulated equipment, with polarity and circuit identification options including grey-with-edge-stripe, 10-colour rainbow sequences and polarity-marked white constructions.

CASMO supplies UL 758 AWM flat ribbon cable series across standard and micro-pitch geometries, providing pre-calculated finished width charts, core-count flexibility and documented dimensional tolerances for reliable IDC mating.

Ribbon Cable Products

  • UL 20674 — UL 758 AWM · TPE · -40°C to +105°C · 150V
  • UL 20596 — UL 758 AWM · PVC · -20°C to +105°C · 150V
  • UL 20346 — UL 758 AWM · TPE · -40°C to +105°C · 300V
  • UL 20297 — UL 758 AWM · TPE · -40°C to +105°C · 150V
  • UL 20080 — UL 758 AWM · PVC · -20°C to +80°C · 30V
  • UL 4478 — UL 758 AWM · XLPE · -20°C to +105°C · 300V
  • UL 2678 — UL 758 AWM · PVC · -20°C to +105°C · 150V
  • UL 2651 — UL 758 AWM · PVC · -20°C to +105°C · 300V
  • UL 2468 — UL 758 AWM · PVC · -20°C to +80°C · 300V

Related Standards, Materials & Applications

Frequently Asked Questions

Does conductor pitch alone determine finished ribbon cable width?
No. Pitch is the centre-to-centre distance between adjacent conductors; overall finished width also depends on core count, edge-insulation geometry (flat-edge vs. rounded-edge web) and extrusion tolerances.
Can any flat ribbon cable be terminated with an IDC connector?
Only when the connector matches the cable's conductor pitch, AWG wire size, stranding and overall insulation thickness. Always verify connector dimensional compatibility against the ribbon specification sheet.
When should I specify halogen-free TPE or XLPE ribbon cable instead of PVC?
Choose halogen-free TPE or cross-linked XLPE ribbon cables when equipment designs require low-smoke zero-halogen compliance, higher temperature ratings, improved flex endurance or stricter environmental material restrictions than standard PVC provides.
How are conductors and Pin 1 identified on flat ribbon cables?
Standard constructions use a contrasting Core-1 edge stripe (such as red or blue on grey insulation), full 10-colour repeating rainbow sequences for individual breakouts, or polarity markings on white-jacketed board-to-board cables.